Gung Fu Pop-Up Drain Assembly 1-1/4" x 8": Sink Install Guide

By Maintenance Depot Plumbing Team · Last reviewed

Quick answer

The Gung Fu 1-1/4" x 8" pop-up drain assembly is a complete lift-rod drain kit for standard bathroom basins, with an anti-clogging design and a dependable seal when closed.

Gung Fu Pop-up Drain Assembly 1-1/4" x 8"

A pop-up drain lets you open and close a bathroom sink with a lift rod behind the tap. The Gung Fu pop-up drain assembly, 1-1/4" x 8" is a complete kit for standard lavatory basins.

Specs at a glance

SpecDetail
ProductPop-up drain assembly
BrandGung Fu
Size1-1/4" x 8"
OperationLift rod
FitsStandard lavatory basins

Features

  • Mechanical lift-rod mechanism for smooth operation
  • Anti-clogging design for good water flow
  • Dependable seal when the stopper is closed
  • Sized for standard bathroom basins (1-1/4")

How to install

  1. Remove the old drain: disconnect the trap, unscrew the locknut and push the old flange up through the sink.
  2. Apply plumber's putty or the supplied gasket under the new flange.
  3. Insert the flange and thread on the drain body from below. Make sure the pivot opening faces the back.
  4. Tighten the locknut so the flange seals evenly.
  5. Insert the stopper and connect the pivot rod through the stopper's loop.
  6. Attach the clevis strap to the lift rod and adjust until the stopper opens and closes fully.
  7. Connect the tailpiece to the trap and test for leaks.

Maintenance

Lift the stopper out every month or two and clean off hair and soap scum to keep the sink draining freely.

Need more length to reach the trap? Add a 1-1/4" x 6" tail piece.

Frequently asked questions

Why will my pop-up stopper not close fully?

Adjust the clevis strap and pivot rod position until the stopper seats properly.

Do I need plumber's putty?

Use putty or the supplied gasket under the flange, following the kit instructions.

How do I clean a pop-up stopper?

Lift or unhook it and remove hair and soap scum every month or two.

Buy Gung Fu Pop-up Drain Assembly 1-1/4" x 8" at Maintenance Depot